Click ranges - Panels not sitting flush when assembling

Published on: 17-Feb 11:22am

Julia F

Published on - 17-Feb 11:22am

If a customer says the back panel or side panel isn’t fitting flush like it’s not square or back board isn’t sitting deep enough in the slot, the problem may be that the small plastic black clip in the joint has moved or come out a bit as shown in the image below. It can easily be pushed back in and then all should fit soundly.


Unable to find an answer?

Looking for anything specific article which resides in general queries? Just browse the various relevant folders and categories and then you will find the desired article.

Contact Us

Confirm Action

Are you sure? You want to perform this action.